Quote:
Originally Posted by Back2RFK
Yes, moisture is getting to the mother board and affecting it in some way. Its a known issue with our oven but it was never recalled. Its not over heating. It works just fine then cuts off the controls will light up but you cannot program anything. Sometimes when you flip the breaker it will work again.
|
If the board itself is properly made and hasn't been damaged condensation on the outside should not effect the pathways. It is probably shorting out at one of the connections. Any chance you could clean all the connections real good with contact cleaner, let them air dry, then use some non conductive liquid electrical tape to keep the moisture out?
03-23-2020, 04:25 PM
Threaded Mode